Upgraded ESD Safe Thru-Hole Soldering/Desoldering Repairing System

Desoldering Gun with Soldering Iron ReWork Station

Designed for all types of Printed Circuit Board repair, easy to operate soldering /desoldering functions.

The desoldering tool comes with zero crossing circuitry preventing electrical surges. and a newly designed single piston pump to enhance the soldering gun suction ability.

The Soldering iron incorporates a ceramic heating element to provide longer service life.

The CSI701A is a high precision thermostatically controlled station that is designed for the needs of the repair technician. Includes a 35W Soldering Iron with a heating range of 392°F to 896°F, and a lightweight desoldering gun with a temperature range of 716°F to 896°. The built in double cylinder vacuum pump provides a constant suction that will quickly and easily remove solder from the work surface. Both tips have a nozzle to ground resistance under 2 ohms and a variable temperature controller that can adjust and lock the thermostat so you maintain a constant temperature when performing critical repair work. Two calibration ports are on the station allowing you to make sure the temperature remains constant each time you change out the tips. Also included is a soldering iron holder with sponge, 6 paper filters, 1 Spring Filter, Cleaning Pin & Drill for nozzle, Silicone Grease to prevent air leakage, 1 1mm Conicle Fine Point Soldering Tip and 3 tips for the desoldering iron (1.0mm, 1.5mm & 1.8mm). All at a price that you can't ignore! Just one of many peices of soldering equipment that Circuit Specialists stocks in the USA.

Circuit Specialists stocks a wide range of soldering and desoldering tips as well as replacements for the soldering wand, heating element and desoldering gun for this unit (see the `Related Products' section at the bottom of this page)

Specifications:

Power Input: 110-120VAC
Station Dimensions: 188(w) x 126(h) x 250(d) mm
Weight: 14 lbs

Soldering Iron

Power Consumption: 35W
Temperature Range: 392°F~896°F (200°C~480°C)
Heating Element with Tip: Ceramic Heater
Output Voltage: 24V
Tip to Ground Resistance: Below 2Ω
Tip to Ground Potential: Below 2mV
Includes (1) KD-M-0.8D 0.8mm Chisel Tip

Desoldering Pistol

Temperature Range: 200 deg C- 380 deg C
Heating element: Ceramic Heater
Output Voltage: 24 V
Suction: Single piston pump. 80kVA

Users Manual